DRIVER SIDE: Diagnosis Procedure: Notes

1. Turn ignition switch OFF.
2. Disconnect front power window motor (driver side) connector.
3. Turn ignition switch ON.
4. Check voltage between power window motor (driver side) harness connector and ground.

   (+)		(--)	Condition		Voltage (V) (Approx.)
   Power window motor (driver side)
   Connector	Terminal
   D7	1	Ground	Power window main switch	UP	0
   				DOWN	Battery voltage
   	2			UP	Battery voltage
   				DOWN	0

   Is the inspection result normal? 

   YES: GO TO  3.

   NO: GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect power window main switch connector.
3. Check continuity between power window main switch harness connector and front power window motor (driver side) harness connector.

   Power window main switch		Front power window motor (driver side)		Continuity
   Connector	Terminal	Connector	Terminal
   D5	8	D7	2	Existed
   	11		1

4. Check continuity between power window main switch harness connector and ground.

   Power window main switch		Ground	Continuity
   Connector	Terminal
   D5	8		Not existed
   	11

   Is the inspection result normal? 

   YES: Replace power window main switch. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace harness.

Check front power window motor (driver side).

Refer to "DRIVER SIDE: COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO 4.

NO: Replace power window motor (driver side). Refer to "REMOVAL AND INSTALLATION ".

Refer to "INTERMITTENT INCIDENT ".

: INSPECTION END