Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2013 >> Juke SL, FWD, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS U0101 To P0128 >> DTC P0097, P0098: IAT Sensor 2 >> DTC Logic >> DTC Detection Logic

DTC Detection Logic

DTC No. Trouble diagnosis name (Trouble diagnosis content) DTC detecting condition Possible cause
P0097 IAT SENSOR 2 B1 (Intake air temperature sensor 2 circuit low input) ECM detects the following status continuously for 5 seconds or more:
A voltage signal transmitted from the intake air temperature sensor 2 is 0.085 V or less.
  • Harness or connectors

    (Intake air temperature sensor 2 circuit is open or shorted.)

    (Fuel rail pressure sensor circuit is open or shorted.)

    (Battery current sensor circuit is open or shorted.)

    (G sensor circuit is open or shorted.)

    (Crankshaft position sensor circuit is open or shorted.)

    (Exhaust valve timing control position sensor circuit is open or shorted.)

    (Accelerator pedal position sensor 2 circuit is open or shorted.)

    (Engine oil pressure sensor circuit is open or shorted.)

  • Intake air temperature sensor 2
  • Turbocharger boost sensor
  • Fuel rail pressure sensor
  • Battery current sensor
  • G sensor
  • Crankshaft position sensor
  • Exhaust valve timing control position sensor
  • Accelerator pedal position sensor 2
  • Engine oil pressure sensor
P0098 IAT SENSOR 2 B1 (Intake air temperature sensor 2 circuit high input) ECM detects the following status continuously for 5 seconds or more:
A voltage signal transmitted from the intake air temperature sensor 2 is 4.84 V or more.
scientia non olet · About Mike's Workshop Manuals