Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2013 >> Juke SL, FWD, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Component Testing, Periodic Maintenance And Removal And Installation >> Fuel Injector >> Component Inspection (Fuel Injector Relay)

Component Inspection (Fuel Injector Relay)

  1. CHECK FUEL INJECTOR RELAY 
    1. Turn ignition switch OFF.
    2. Remove fuel injector relay.
    3. Check the continuity between fuel heater relay terminals as per the following conditions.
      Fuel injector relay Conditions Continuity
      + -
      Terminal
      3 5 12 V direct current supply between terminals 1 and 2 Existed
      No current supply Not existed
      6 7 12 V direct current supply between terminals 1 and 2 Existed
      No current supply Not existed
      Fig 1: Checking Continuity Between Fuel Heater Relay Terminals
      G08690411Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace fuel injector relay.

scientia non olet · About Mike's Workshop Manuals