Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2013 >> Cube SL >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security Control System (With Intelligent Key System) >> System Description >> NISSAN Vehicle Immobilizer System-NATS >> System Description >> Engine Start Operation When Intelligent Key Is Contacted To Push-Button Ignition Switch

Engine Start Operation When Intelligent Key Is Contacted To Push-Button Ignition Switch

  1. When brake pedal is depressed while selector lever is in the P position, BCM activates immobilizer antenna amplifier that is located on push-button ignition switch backside.
  2. When Intelligent Key (transponder built-in) backside is contacted to push-button ignition switch, immobilizer ID verification is started between Intelligent Key built-in transponder and immobilizer antenna amplifier.
  3. When immobilizer ID verification result is OK, buzzer in combination meter sounds.
  4. BCM transmits immobilizer ID verification result to ECM via CAN communication.
  5. BCM turns ACC relay ON and transmits ignition power supply ON signal to IPDM E/R.
  6. IPDM E/R turns ignition relay ON and starts ignition power supply.
  7. BCM detects that the shift position is P or N.
  8. BCM transmits starter request signal to IPDM E/R via CAN communication.

    When engine start conditions* are satisfied, BCM turns starter relay in IPDM E/R ON.

  9. When starter request signal is received, IPDM E/R turns starter control relay ON.
  10. IPDM E/R supplies power supply via starter relay and starter control relay, activates starter motor, and starts cranking.
  11. When BCM receives engine start or speed feedback signal from ECM, BCM transmits stop signal to IPDM E/R, turns starter relay OFF, and stops cranking.
scientia non olet · About Mike's Workshop Manuals