Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2013 >> Altima Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Power Control System (Power Distribution System)) >> Removal And Installation >> Push-Button Ignition Switch >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Cube. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the switch panel finisher. Refer to "REMOVAL AND INSTALLATION ".
  2. Disconnect the push-ignition switch (2) fixing pawl using a flat-blade screwdriver (A), and then remove NATS antenna amp..
    Fig 1: Disconnecting Push-Ignition Switch Fixing Pawl Using Screwdriver
    G08702328Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals