ECM: Special Repair Requirement

WARNING: This page is about a different car, the 2013 Nissan Cube. However, it is still accessible from the selected car via links, so may be relevant.

PERFORM ECM RECOMMUNICATING FUNCTION
1. Install ECM.
2. Insert the registered ignition key* into key cylinder, then turn ignition switch ON.
  *: To perform this step, use the key that is used before performing ECM replacement.
3. Maintain ignition switch in the ON position for at least 5 seconds.
4. Turn ignition switch OFF.
5. Start engine.
  : GO TO 2.
PERFORM ADDITIONAL SERVICE PROCEDURE WHEN REPLACING ECM
performing the following procedure.
- HR18DE (Except for California): "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT: SPECIAL REPAIR REQUIREMENT "
- HR18DE (For California): "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT: SPECIAL REPAIR REQUIREMENT "
  : END