Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2013 >> 370Z Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0137 To P0448 >> DTC P0196: EOT Sensor >> Component Inspection

Component Inspection

  1. CHECK ENGINE OIL TEMPERATURE SENSOR 
    1. Turn ignition switch OFF.
    2. Disconnect engine oil temperature sensor harness connector.
    3. Remove engine oil temperature sensor. Refer to "EXPLODED VIEW ".
    4. Check resistance between engine oil temperature sensor terminals by heating with hot water as shown in the figure below.
      Terminals Condition Resistance (kΩ)
      1 and 2 Temperature [°C (°F)] 20 (68) 2.10 - 2.90
      50 (122) 0.68 - 1.00
      90 (194) 0.236 - 0.260
      Fig 1: Checking Resistance Between Engine Oil Temperature Sensor Terminals
      G08674826Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace engine oil temperature sensor.

scientia non olet · About Mike's Workshop Manuals