Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Xterra PRO-4X, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS U0101 To P0183 >> DTC P0125: ECT Sensor >> DTC Confirmation Procedure >> With Consult

With Consult

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT.
  3. Check that "COOLAN TEMP/S" is above 20°C (68°F).

    If the temperature is above 20°C (68°F), the test result will be OK. 

    If the temperature is below 20°C (68°F), go to following step. 

  4. Start engine and run it for 65 minutes at idle speed.

    If "COOLAN TEMP/S" increases to more than 20°C (68°F) within 65 minutes, stop engine because the test result will be OK. 

  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals