Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Xterra PRO-4X, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0222 To P0603 >> DTC P0442: EVAP Control System >> DTC Confirmation Procedure >> With Consult

With Consult

  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
  4. Make sure that the following conditions are met.

    COOLAN TEMP/S: 0 - 70°C (32 - 158°F) 

    INT/A TEMP SE: 0 - 30°C (32 - 86°F) 

  5. Select "EVP V/S LEAK P0456/P1456" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT.

    Follow the instructions displayed.

    NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT screen, go to "BASIC INSPECTION ".
  6. Make sure that "OK" is displayed.

If "NG" is displayed, refer to "DIAGNOSIS PROCEDURE ".

NOTE: Make sure that EVAP hoses are connected to EVAP canister purge volume control solenoid valve properly.
scientia non olet · About Mike's Workshop Manuals