DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

   : GO TO 2.

Check engine oil level. Refer to "INSPECTION ".

Is inspection result normal? 

YES: GO TO 3.

NO: Check engine oil leak. Refer to "INSPECTION ".

1. Start engine and let it idle for at least 5 seconds.
2. Check 1st trip DTC.

   Is 1st trip DTC detected? 

   YES: Proceed to "DIAGNOSIS PROCEDURE ".

   NO: INSPECTION END