ID Registration Without Transmitter Activation Tool
- Decrease air pressure for at least 30 seconds continuously for each tire (more than 10 psi (34.5 kPa) within 30 seconds) to place the TPM system into relearn mode for 30 minutes.
- Adjust the tire pressure for all wheels as indicated in the Sensor ID Registration Tire Pressure Specifications table.Sensor ID Registration Tire Pressure Specifications
Tire Position Tire Pressure - psi (kPa) Front Left 25 (172) Front Right 40 (276) Rear Right 60 (414) Rear Left 80 (551) - Start the Registration procedure using the INFO knob as follows: SETTINGS ->RESET TPMS ->RELEARN ->RESETTING. The TPMS warning lamp flashes continuously when the system is relearning the tire positions. See Fig 1.NOTE: If the Registration procedure is stopped before completion, the new tire positions are not learned. Perform the complete relearn procedure again to reset the tire positions.
- When the Registration procedure is successfully completed the TPMS warning lamp illuminates for 3 seconds and a chime sounds 3 times.
- Adjust the tire pressures to the cold tire pressure specification. If the tire pressures are correct, the TPMS warning lamp turns OFF.
NOTE:
If the Registration procedure does not work, check the following and retry the procedure:
- If the relearn procedure is stopped before completion, the new tire positions are not learned. Perform the complete relearn procedure again to reset the tire positions. You must select: RESET TPMS, RELEARN from the SETTINGS menu to complete the relearn procedure. Perform the complete relearn procedure to reset the tire positions. Select the TPMS resetting menu, then continue the remaining registration procedure.
- Adjust the tire pressures to the relearn pressures before selecting the TPMS resetting menu on the display. Perform the complete relearn procedure to reset the tire positions.
- If the tire pressure cannot be reduced at least 10 psi (34.5 kPa) to adjust them to the relearn pressures, inflate the tires to at least 10 psi (34.5 kPa) above the specified pressures. Perform the complete relearn procedure starting with step 1.
- Devices which emit electronic interference should be turned OFF before starting the relearn procedure. The interference may prevent the system from learning the new tire positions. Turn OFF or remove sources of electrical interference. If necessary, move the vehicle to another location, then perform the complete relearn procedure to reset the tire positions.
- Use an air pump that is capable of inflating the tires to the required pressure specifications. The air pump must be capable of inflating a tire at least 10 psi (34.5 kPa) in 30 seconds.
- If the reset TPMS function is unintentionally selected, place the ignition switch in the OFF position, then to the ON position to end the relearn procedure.
- If the vehicle is not recognizing the new tire pressure levels, move the vehicle forward 40 inches (1 meter). Place the ignition switch in the OFF position, then to the ON position. Perform the relearn procedure beginning at step 1. Make sure that the tire pressures are increased or decreased at least 10 psi (34.5 kPa).
- If tire pressure is not set to the correct pressure, perform the procedure again.