DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle .
Always perform the test at a temperature above 0°C (32°F)

With CONSULT

Turn ignition switch ON.
Select "DATA MONITOR" mode with CONSULT.
Make sure that "COOLAN TEMP/S" indicates between 5°C (41°F) to 45°C (113°F).
If not, cool engine down or warm engine up until "COOLAN TEMP/S" indicates between 5°C (41°F) to 45°C (113°F). Then go to the following steps.
Fully release accelerator pedal and wait at least 5 seconds.
Depress accelerator pedal and wait at least 5 seconds.
Check 1st trip DTC.
If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
With GST

Following the procedure "With CONSULT" above.