Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Control System - DTCS P1212 To P2A00 (MR20DE) (CALIFORNIA)) >> DTC P1715: Input Speed Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION: Always drive vehicle at a safe speed.
NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

With CONSULT

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT.
  3. Start engine.
  4. Drive vehicle at a speed of more than 50 km/h (31 MPH) for at least 5 seconds.
  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

With GST

Follow the procedure "With CONSULT" above.

scientia non olet · About Mike's Workshop Manuals