Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Control System - DTCS P1212 To P2A00 (MR20DE) (CALIFORNIA)) >> DTC P1225: TP Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 10 V at idle  .

  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Check 1st trip DTC.
  4. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals