Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System - DTCS P0447 To P1148 (MR20DE) (CALIFORNIA)) >> DTC P0462, P0463: Fuel Level Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 11 V at ignition switch ON  .

  1. Turn ignition switch ON and wait at least 5 seconds.
  2. Check 1st trip DTC.
  3. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals