DTC Confirmation Procedure

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 10.5 V at idle  .

WITH CONSULT

1. Start engine and warm it up to normal operating temperature.
2. Select "A/F SEN1 (B1)" or "A/F SEN 1 (B2)" in "DATA MONITOR" mode with CONSULT.
3. Check "A/F SEN1 (B1)" or "A/F SEN 1 (B2)" indication.

   If the indication is constantly approx. 5 V, go to "DIAGNOSIS PROCEDURE ".

   If the indication is not constantly approx. 5 V, go to next step.

4. Turn ignition switch OFF, wait at least 10 seconds and then restart engine.
5. Drive and accelerate vehicle to more than 40 km/h (25 MPH) within 20 seconds after restarting engine.
6. Maintain the following conditions for approximately 20 consecutive seconds.

   ENG SPEED	1, 000 - 3, 200 rpm
   VHCL SPEED SE	More than 40 km/h (25 MPH)
   B/FUEL SCHDL	1.5 - 9.0 msec
   Selector lever	Suitable position

   NOTE:

   • Keep the accelerator pedal as steady as possible during the cruising.
   • If this procedure is not completed within 1 minute after restarting engine at step 4, return to step  4.
7. Check 1st trip DTC.
8. If 1st trip DTC is displayed, go to "DIAGNOSIS PROCEDURE ".

   WITH GST

   Follow the procedure "WITH CONSULT" above.