Procedure For Malfunction B

With CONSULT

1. Start engine and warm it up to normal operating temperature.
2. Select "A/F SEN1 (B1)" or "A/F SEN 1 (B2)" in "DATA MONITOR" mode with CONSULT.
3. Check "A/F SEN1 (B1)" or "A/F SEN 1 (B2)" indication.

   If the indication is constantly approx. 2.2 V and does not fluctuates, go to "DIAGNOSIS PROCEDURE ".

   If the indication fluctuates around 2.2 V, go to next step.

4. Select "A/F SEN1 (B1) P1276" (for P0130) or "A/F SEN 1 (B2) P1286" (for DTC P0150) of "A/F SEN1" in "DTC WORK SUPPORT" mode with CONSULT.
5. Touch "START".
6. When the following conditions are met, "TESTING" will be displayed on the CONSULT screen.

   ENG SPEED	1, 000 - 3, 200 rpm
   VHCL SPEED SE	More than 64 km/h (40 MPH)
   B/FUEL SCHDL	1.0 - 11.5 msec
   Selector lever	D position (CVT) 5th position (M/T)

   If "TESTING" is not displayed after 20 seconds, retry from step 2  .

7. Release accelerator pedal fully.
   NOTE: Never apply brake during releasing the accelerator pedal.
8. Check that "TESTING" changes to "COMPLETED".

   If "TESTING" changed to "OUT OF CONDITION", retry from step 6  .

9. Check that "OK" is displayed after touching "SELF-DIAG RESULTS".

If "NG" is displayed, go to "DIAGNOSIS PROCEDURE ".