Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Sentra SE-R >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0603 To P2A03 (Qr25DE) >> DTC P0850: PNP Switch >> Diagnosis Procedure >> M/T Models

M/T Models

  1. CHECK PNP SWITCH POWER SUPPLY CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect PNP switch harness connector.
    3. Turn ignition switch ON.
    4. Check voltage between PNP switch terminal 1 and ground with CONSULT or tester.

    Voltage: Battery voltage 

    Fig 1: Checking PNP Switch Power Supply Circuit
    G04926131Courtesy of NISSAN NORTH AMERICA, INC.

    OK or NG 

    OK: GO TO  3.

    NG: GO TO 2.

  2. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors M2, E4
    • Harness connectors E3, F2
    • 10 A fuse
    • Harness for open or short between PNP switch and fuse

    Repair open circuit or short to ground or short to power in harness or connectors.

  3. CHECK PNP SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check harness continuity between PNP switch terminal 2 and ECM terminal 102. Refer to Wiring Diagram .

      Continuity should exist  .

    4. Also check harness for short to ground and short to power.

    OK or NG 

    OK: GO TO  5.

    NG: GO TO 4.

  4. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors F2, E3
    • Harness for open or short between PNP switch and ECM

    Repair open circuit or short to ground or short to power in harness or connectors.

  5. CHECK PNP SWITCH

    Refer to POSITION SWITCH .

    OK or NG 

    OK: GO TO 6.

    NG: Replace PNP switch. Refer to , "DISASSEMBLY AND ASSEMBLY ".

  6. CHECK INTERMITTENT INCIDENT

    Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT .

    INSPECTION END