Power Supply and Ground Circuit Inspection

1. Turn ignition switch OFF.
2. Disconnect Intelligent Key unit connector.
3. Check voltage between Intelligent Key unit harness connector M42 terminals 6, 11 and ground.

   Connector	Terminals		Ignition switch position
   M42	(+)	(-)	OFF	ON
   	6	Ground	0V	Battery voltage
   	11		Battery voltage	Battery voltage

   Fig 1: Checking Power Supply Circuit

   Courtesy of NISSAN NORTH AMERICA, INC.

   OK or NG 

   OK: GO TO 2.

   NG: Repair or replace Intelligent Key power supply circuit.

Check continuity between Intelligent Key unit harness connector M42 terminal 12 and ground.

12 - Ground: Continuity should exist  .

Fig 2: Checking Ground Circuit

Courtesy of NISSAN NORTH AMERICA, INC.

OK or NG 

OK: Power supply and ground circuits are OK.

NG: Repair or replace the Intelligent Key unit ground circuit.