Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Sentra Base, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS U0101 To P0132 (MR20DE) (CALIFORNIA) >> DTC P0125: ECT Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

CAUTION: Be careful not to overheat engine.
NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

With CONSULT

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT.
  3. Check that "COOLAN TEMP/S" is above -4°C (25°F).

    If it is above -4°C (25°F), the test result will be OK  .

    If it is below -4°C (25°F), go to following step  .

  4. Start engine and run it for 65 minutes at idle speed.

    If "COOLAN TEMP/S" increases to more than -4°C (25°F) within 65 minutes, stop engine because the test result will be OK  .

  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

With GST

Follow the procedure "With CONSULT" above.

scientia non olet · About Mike's Workshop Manuals