Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Sentra Base, Automatic CVT Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System - Component Testing (MR20DE) (Except CALIFORNIA) >> Fuel Injector >> Component Inspection >> Fuel Injector

Fuel Injector

  1. Disconnect fuel injector harness connector.
  2. Check resistance between terminals as shown in the figure.

    Resistance: 11.1 - 14.5 Ω [at 10 - 60°C (50 - 140°F)] 

  3. If NG, replace fuel injector. Refer to FUEL INJECTOR AND FUEL TUBE .
Fig 1: Checking Resistance Between Fuel Injector Harness Connector Terminals 1 And 2
G04925628Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals