BSW CONTROL MODULE : Diagnosis Procedure
WARNING: This page is about a different car, the 2011 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM THE SELF-DIAGNOSIS
- Turn the ignition switch ON.
- Turn the BSW system ON, and then wait for 2 seconds or more.
- Perform "All DTC Reading" with CONSULT.
- Check if the "U1000" is detected as the current malfunction in "Self Diagnostic Result" of "BSW".
Is "U1000" detected as the current malfunction?
YES: Refer to "TROUBLE DIAGNOSIS FLOW CHART ".
NO: Refer to "INTERMITTENT INCIDENT ".