Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Quest LE >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Security Control System) >> Removal And Installation >> Push-Button Ignition Switch >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2011 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove instrument finisher A. Refer to "REMOVAL AND INSTALLATION ".
  2. Disconnect NATS antenna amp. connector and push-button ignition switch connector.
  3. Disengage the push-button ignition switch fixing pawls by pushing them in the direction of the arrow (1) as shown in the figure.
    Fig 1: Locating Push-Button Ignition Switch
    G07052428Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Push push-button ignition switch (1) in the direction of the arrow (2), as shown in the figure, and remove push-button ignition switch from NATS antenna amp (2).
scientia non olet · About Mike's Workshop Manuals