Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Juke SL, FWD, Automatic CVT Trans >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security Control System (With Intelligent Key System) >> DTC/Circuit Diagnosis >> DTC B26F3: Starter Control Relay >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PERFORM DTC CONFIRMATION PROCEDURE
    1. Press push-button ignition switch under the following conditions to start engine.

      CVT models

      • Selector lever: In the P position
      • Brake pedal: Depressed

      M/T models

      • Shift lever: In the Neutral position
      • Clutch pedal: Depressed
    2. Wait 2 seconds after engine started.
    3. Check DTC in "Self Diagnostic Result" mode of "BCM" using CONSULT.

      Is DTC detected? 

      YES: Go to "DIAGNOSIS PROCEDURE ".

      NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals