Removal and Installation: Installation

WARNING: This page is about a different car, the 2011 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

NOTE:

When replacing the BCM, it must be configured. Refer to "CONFIGURATION : SPECIAL REPAIR REQUIREMENT ".
When replacing the BCM, if equipped with NATS perform initialization of NATS system and registration of all NATS ignition key IDs. Refer to "CONFIGURATION : SPECIAL REPAIR REQUIREMENT ".
When replacing the BCM, perform ID registration procedure of low tire pressure warning system. Refer to "ID REGISTRATION PROCEDURE ".
When replacing the BCM, if equipped with remote keyless entry, register the remote keyless entry system keyfob ID codes. Refer to "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : SPECIAL REPAIR REQUIREMENT ".
When replacing the BCM, perform adjustment procedure for the steering angle sensor if equipped. Refer to "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION : SPECIAL REPAIR REQUIREMENT " (type 2) or "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION : SPECIAL REPAIR REQUIREMENT " (type 3).