Immobilizer code is not identified
WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
If the immobilizer code is not identified, the immobilizer indicator quickly flashes once, then blinks until the ignition switch is turned to LOCK (0). When the ignition switch is turned to LOCK (0), the indicator blinks ten times, then goes OFF to show the system is correctly reset.
The state of the immobilizer key registration and the S-NET line can be checked by doing a SYSTEM CHECK (see SYSTEM CHECK ), and STATUS LOG CHECK (see STATUS LOG ) with the HDS.