Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (PGM-FI System) >> Knock Sensor Replacement

Knock Sensor Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold (see INTAKE MANIFOLD REMOVAL AND INSTALLATION ).
  2. Remove the injector base (see INJECTOR BASE REMOVAL AND INSTALLATION ).
  3. Disconnect the knock sensor 1P connector (A).
    Fig 1: Identifying Knock Sensor 1P Connector
    G08057181Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the knock sensor (B).
  5. Install the parts in the reverse order of removal.
scientia non olet · About Mike's Workshop Manuals