Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Wiper System / Washer System) >> Wiper/Washer Switch Replacement

Wiper/Washer Switch Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The wiper/washer switch is built into the combination switch control unit. For the wiper/washer test, refer to the combination switch control unit input test 
  1. Remove the steering column covers (see COLUMN COVER REMOVAL/INSTALLATION ).
  2. Disconnect the combination light switch 10P connector (A), and dashboard wire harness 8P connector (B) from the wiper/washer switch (C).
    Fig 1: Identifying 10P Connector, 8P Connector And Wiper/Washer Switch
    G08055444Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the two screws, then slide out the wiper/washer switch.
scientia non olet · About Mike's Workshop Manuals