Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Wiper System / Washer System) >> Washer Fluid Level Switch Test

Washer Fluid Level Switch Test

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right inner fender (see FRONT INNER FENDER REPLACEMENT ).
  2. Disconnect the 2P connector (A) from the washer fluid level switch.
    Fig 1: Identifying 2P Connector And Washer Fluid Level Switch
    G08055451Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the washer fluid level switch from the washer reservoir.
    NOTE: Fluid may flow out of the opening.
  4. Check for continuity between terminals No. 1 and No. 2 in each float position.
    • There should be continuity when the float is down.
    • There should be no continuity when the float is up.
  5. If the continuity is not as specified, replace the switch.
scientia non olet · About Mike's Workshop Manuals