DTC B1065: Relay Control Module Lost Communication with Driver's MPCS Unit (DRLOCKSW Message)
WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see
TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Wait for at least 6 seconds.
- Check for DTCs with the HDS.
Is DTCs B1065 indicated?
YES -Go to step 5.
NO -Intermittent failure, the system is OK at this time. Check for loose or poor connections between the relay control module and the driver's MPCS unit.
- Check for DTCs with the HDS.
Are DTCs B1015, B1065, B1182, B1356, and B1905 all indicated?
YES -Do the driver's MPCS unit input test (see DRIVER'S MPCS UNIT INPUT TEST ).
NO -Do the relay control module input test (see RELAY CONTROL MODULE INPUT TEST ).