Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security Control System (With Intelligent Key System) >> DTC/Circuit Diagnosis >> DTC P1610: Lock Mode >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK ENGINE START FUNCTION
    1. Perform the check for DTC except DTC P1610.
    2. Use CONSULT to erase DTC after fixing.
    3. Turn ignition switch OFF.
    4. Turn ignition switch ON when registered Intelligent Key backside is contacted to push-button ignition switch and wait for 5 seconds.
    5. Turn the ignition switch OFF and wait 5 seconds.
    6. Repeat steps  4 and  5 twice (a total of 3 times).
    7. Check that engine can start when registered Intelligent Key backside is contacted to push-button ignition switch.

      >> INSPECTION END

scientia non olet · About Mike's Workshop Manuals