Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2012 >> Altima Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Control System - Component Testing (VQ35DE)) >> ASCD Brake Switch >> Component Inspection (ASCD Brake Switch)

Component Inspection (ASCD Brake Switch)

WARNING: This page is about a different variant/trim than selected.
  1. CHECK ASCD BRAKE SWITCH-I
    1. Turn ignition switch OFF.
    2. Disconnect ASCD brake switch harness connector.
    3. Check the continuity between ASCD brake switch terminals under the following conditions.
      Terminals Condition Continuity
      1 and 2 Brake pedal Fully released Existed
      Slightly depressed Not existed
      Fig 1: Checking ASCD Brake Switch-I
      G08433660Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: GO TO 2.

  2. CHECK ASCD BRAKE SWITCH-II
    1. Adjust ASCD brake switch installation. Refer to "INSPECTION AND ADJUSTMENT ".
    2. Check the continuity between ASCD brake switch terminals under the following conditions.
      Terminals Condition Continuity
      1 and 2 Brake pedal Fully released Existed
      Slightly depressed Not existed
      Fig 2: Checking ASCD Brake Switch-II
      G08433661Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace ASCD brake switch. Refer to "EXPLODED VIEW ".

scientia non olet · About Mike's Workshop Manuals