Removal and Installation: Installation

Installation is in the reverse order of removal.

For removal/installation of the direct-connect SRS connectors, refer to "DIRECT-CONNECT SRS COMPONENT CONNECTORS ".
If driver air bag module is being replaced due to deployment, spiral cable must also be replaced. Refer to SPIRAL CABLE .
After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to "SRS OPERATION CHECK ".

CAUTION:

Make sure driver air bag module harness (1) is routed properly to avoid SRS component damage during installation.

Fig 1: Identifying Driver Air Bag Module Harness
Courtesy of NISSAN MOTOR CO., U.S.A.