Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2011 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - Introduction (MR20DE) (CALIFORNIA)) >> Service Information >> Trouble Diagnosis >> CONSULT-III Function (ENGINE) >> Work Support Mode

Work Support Mode

WARNING: This page is about a different variant/trim than selected.

Work Item

WORK ITEMS CONDITION CHART

Work item Condition Usage
FUEL PRESSURE RELEASE Fuel pump will stop by touching "START" during idling. Crank a few times after engine stalls. When releasing fuel pressure from fuel line
IDLE AIR VOL LEARN The idle air volume that keeps the engine within the specified range is memorized in ECM. When learning the idle air volume
SELF-LEARNING CONT The coefficient of self-learning control mixture ratio returns to the original coefficient. When clearing the coefficient of self-learning control value
EVAP SYSTEM CLOSE Close the EVAP canister vent control valve in order to make EVAP system close under the following conditions.
  • IGN SW "ON"
  • Engine not running
  • Ambient temperature is above 0°C (32°F).
  • No vacuum and no high pressure in EVAP system
  • Fuel tank temp. is more than 0°C (32°F).
  • Within 10 minutes after starting "EVAP SYSTEM CLOSE"
  • When trying to execute "EVAP SYSTEM CLOSE" UNDER The condition except above, CONSULT-III will discontinue it and display appropriate instruction.
NOTE: When starting engine, CONSULT-III may display "BATTERY VOLTAGE IS LOW. CHARGE BATTERY", even in using charged battery.
 When detecting EVAP vapor leak point of EVAP system
TARGET IDLE RPM ADJ(1) Idle condition When setting target idle speed
TARGET IGN TIM ADJ(1) Idle condition When adjusting target ignition timing
VIN REGISTRATION In this mode, VIN is registered in ECM. When registering VIN in ECM
CLSD THL POS LEARN Ignition on and engine stopped. When learning the throttle valve closed position
(1) This function is not necessary in the usual service procedure.
scientia non olet · About Mike's Workshop Manuals