Intake Valve Timing Control Solenoid Valve

Disconnect intake valve timing control solenoid valve harness connector.

Check resistance between intake valve timing control solenoid valve as follows.

TERMINAL RESISTANCE REFERENCE CHART

Terminal	Resistance
1 and 2	6.7 - 7.7 Ω [at 20°C (68°F)]
1 or 2 and ground	∞Ω (Continuity should not exist.)

Fig 1: Checking Resistance Between Intake Valve Timing Control Solenoid Valve

Courtesy of NISSAN MOTOR CO., U.S.A.

If NG, replace intake valve timing control solenoid valve. Refer to "REMOVAL AND INSTALLATION ".

If OK, GO TO next step.

Remove intake valve timing control solenoid valve. Refer to "REMOVAL AND INSTALLATION ".
Provide 12 V DC between intake valve timing control solenoid valve terminals and then interrupt it. Check that the plunger moves as shown in the figure.

CAUTION: Never apply 12 V DC continuously for 5 seconds or more. Doing so may result in damage to the coil in intake valve timing control solenoid valve. If NG, replace intake valve timing control solenoid valve. Refer to "INSPECTION AFTER INSTALLATION ".

Fig 2: Applying 12V DC Between Intake Valve Timing Control Solenoid Valve Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

NOTE: Always replace O-ring when intake valve timing control solenoid valve is removed.