Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2011 >> Sentra SE-R >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0181 To P0500 (MR20DE) (Except CALIFORNIA) >> DTC P0500 VSS >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    TESTING CONDITION: 

    Before performing the following procedure, confirm that battery voltage is 10 V or more at idle  .

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE
    1. Start engine.
    2. Shift the selector lever to D range and wait at least for 2 seconds.
    3. Drive the vehicle at least 5 seconds at 20 km/h (13 MPH) or more.
      CAUTION: Always drive vehicle at a safe speed.
      NOTE: This procedure may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.
    4. Check 1st trip DTC.

      Is 1st trip DTC detected? 

      YES: Proceed to "DIAGNOSIS PROCEDURE ".

      NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals