Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2011 >> Sentra SE-R >> Repair and Diagnosis >> Body & Frame >> Windows >> Glass, Window System & Mirrors >> Service Information >> Power Window System >> Power Window and Door Lock/Unlock Switch RH Power Supply Circuit Inspection

Power Window and Door Lock/Unlock Switch RH Power Supply Circuit Inspection

  1. CHECK POWER SUPPLY CIRCUIT
    1. Turn ignition switch ON.
    2. Check voltage between power window and door lock/unlock switch RH connector D104 terminal 8 and ground.

      8 - Ground : Battery voltage 

      Fig 1: Checking Voltage Between Power Window And Door Lock/Unlock Switch Rh Connector D104 Terminal 8 And Ground
      G04927871Courtesy of NISSAN MOTOR CO., U.S.A.

      OK or NG 

      OK: Replace power window and door lock/unlock switch RH. Refer to "REMOVAL AND INSTALLATION ".

      NG: GO TO 2.

  2. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH POWER SUPPLY CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect BCM and power window and door lock/unlock switch RH.
    3. Check continuity between BCM connector (A) and power window and door lock/unlock switch RH connector (B).
      CONTINUITY SPECIFICATIONS

      A B Continuity
      Connector Terminal Connector Terminal
      M20 68 D104 8 Yes
      Fig 2: Checking Continuity Between BCM Connector (A) And Power Window And Door Lock/Unlock Switch RH Connector (B)
      G04927872Courtesy of NISSAN MOTOR CO., U.S.A.
    4. Check continuity between BCM connector (A) and ground.
      CONTINUITY SPECIFICATIONS

      A Ground Continuity
      Connector Terminal
      M20 68 No

      OK or NG 

      OK: Check the condition of the harness and the connector.

      NG: Repair or replace harness.

scientia non olet · About Mike's Workshop Manuals