Component Inspection (Condenser-1)
- Turn ignition switch OFF.
- Disconnect condenser-1 harness connector. For the condenser number, refer to "WIRING DIAGRAM - ENGINE CONTROL SYSTEM - ". For the condenser layout, refer to "ENGINE CONTROL HARNESS ".
- Check resistance between condenser-1 terminals as follows.
RESISTANCE REFERENCE CHART
| Terminals | Resistance |
| 1 and 2 | Above 1 MΩ [at 25°C (77°F)] |
Is the inspection result normal?
YES: INSPECTION END
NO: Replace condenser-1.