Component Inspection
- Disconnect combination switch (spiral cable) harness connector M352.
- Check the continuity between combination switch harness connector terminals under following conditions.
CONTINUITY REFERENCE CHART
| Combination meter | Condition | Resistance | |
|---|---|---|---|
| Connector | Terminals | ||
| M352 | 18 and 21 | MAIN switch: Pressed | Approx. 0 Ω |
| CANCEL switch: Pressed | Approx. 250 Ω | ||
| SET/COAST switch: Pressed | Approx. 660 Ω | ||
| RESUME/ACCELERATE switch: Pressed | Approx. 1,480 Ω | ||
| All ASCD steering switches: Released | Approx. 4,000 Ω | ||
Is the inspection result normal?
YES: INSPECTION END
NO: Replace ASCD steering switch. Refer to "REMOVAL AND INSTALLATION ".