DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

Go to 2.

1. Start engine and warm it up to the normal operating temperature.
2. Repeat the following procedure 3 times.
   • Drive vehicle at a speed of 80 km/h (50 MPH) or more for at least 3 consecutive minutes.
     CAUTION: Always drive vehicle in safe manner according to traffic conditions and obey all traffic laws.
     NOTE:

     • Keep the vehicle speed as steady as possible during the cruising.
     • Never raise engine speed above 3, 600 RPM in this step.
   • Release accelerator pedal fully and stop vehicle with engine running.
   NOTE: Never turn ignition switch OFF.
3. Check 1st trip DTC.

Is 1st tip DTC detected? 

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END