Diagnosis Procedure

1. Remove mechanical key from key cylinder.
2. Disconnect key switch connector.
3. Check voltage between ignition knob switch, key switch and key lock solenoid harness connector and ground.
   VOLTAGE REFERENCE CHART
   
   

   (+)		(-)	Voltage (V) (Approx.)
   Ignition knob switch, key switch and key lock solenoid
   Connector	Terminal
   M25	2	Ground	Battery voltage

   Is the inspection result normal? 

   YES: Go to 2.

   NO: Repair or replace harness.

1. Check continuity between BCM harness connector and ignition knob switch, key switch and key lock solenoid connector.
   CONTINUITY REFERENCE CHART
   
   

   BCM		Ignition knob switch, key switch and key lock solenoid		Continuity
   Connector	Terminal	Connector	Terminal
   M65	37	M25	1	Exists

2. Check continuity between key switch and ground.
   CONTINUITY REFERENCE CHART
   
   

   Ignition knob switch, key switch and key lock solenoid		Ground	Continuity
   Connector	Terminal
   M25	1		Does not exist

   Is the inspection result normal? 

   YES: Go to 3.

   NO: Repair or replace harness.

Check key switch function.

Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

yes: Go to 4.

NO: Replace ignition knob switch, key switch and key lock solenoid.

Refer to "INTERMITTENT INCIDENT ".

INSPECTION END