DTC Confirmation Procedure

PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
  TESTING CONDITION:
  
  Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.
  
  GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A
1. Start engine and warm it up to normal operating temperature.
2. Let it idle for 2 minutes.
3. Check 1st trip DTC.
  Is 1st trip DTC detected?
  
  YES >> Go to "DIAGNOSIS PROCEDURE ".
  
  NO-1 >> With CONSULT-III: GO TO 3.
  
  NO-2 >> Without CONSULT-III: GO TO 7.
CHECK AIR FUEL RATIO (A/F) SENSOR 1 FUNCTION
1. Start engine and warm it up to normal operating temperature.
2. Select "A/F SEN1 (B1)" or "A/F SEN1 (B2)" in "DATA MONITOR" mode with CONSULT-III.
3. Check "A/F SEN1 (B1)" or "A/F SEN1 (B2)" indication.
  Does the indication fluctuate around 2.2 V?
  
  YES >> GO TO 4.
  
  NO >> Go to "DIAGNOSIS PROCEDURE ".

PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B-I

Select "A/F SEN1 (B1) P1276" (for DTC P0130) or "A/F SEN1 (B2) P1286" (for DTC P0150) of "A/F SEN1" in "DTC WORK SUPPORT" mode with CONSULT-III.
Touch "START".

When the following conditions are met, "TESTING" will be displayed on the CONSULT-III screen.

VEHICLE SPEED CHART

ENG SPEED	1, 000 - 3, 200 RPM
VHCL SPEED SE	More than 64 km/h (40 mph)
B/FUEL SCHDL	1.0 - 8.0 m.sec
Selector lever	D position

If "TESTING" is not displayed after 20 seconds, retry from step 2.

CAUTION: Always drive vehicle at a safe speed.

Is "TESTING" displayed on CONSULT-III screen?

YES >> GO TO 5.

NO >> Check A/F sensor 1 function again. GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B-II
Release accelerator pedal fully.

NOTE: Never apply brake when releasing the accelerator pedal.

Which does "TESTING" change to?

COMPLETED >> GO TO 6.

OUT OF CONDITION >> Retry DTC CONFIRMATION PROCEDURE. GO TO 4.
PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B-III
Touch "SELF-DIAG RESULT".

Which is displayed on CONSULT-III screen?

OK >> INSPECTION END

NG >> Go to "DIAGNOSIS PROCEDURE ".
PERFORM COMPONENT FUNCTION CHECK FOR MALFUNCTION B
Perform component function check. Refer to "COMPONENT FUNCTION CHECK ".

NOTE: Use component function check to check the overall function of the A/F sensor 1 circuit. During this check, a 1st trip DTC might not be confirmed.

Is the inspection result normal?

YES >> INSPECTION END

NO >> Go to "DIAGNOSIS PROCEDURE ".