DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is between 10 V and 16 V at idle. 

Go to 2.

With CONSULT-III 

1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
2. Start engine and warm it up to normal operating temperature.
3. Maintain the following conditions for at least 6 consecutive seconds. Hold the accelerator pedal as steady as possible.
   ENGINE OPERATING CONDITION CHART
   
   

   ENG SPEED	1,200 - 2,000 RPM
   COOLAN TEMP/S	More than 60°C (140°F)
   B/FUEL SCHDL	More than 4.2 msec
   Selector lever	P or N position (CVT) Neutral position (M/T)

4. Stop vehicle with engine running and let engine idle for 10 seconds.
5. Check 1st trip DTC.

   With GST 

   Follow the procedure "With CONSULT-III" above.

   Is 1st trip DTC detected? 

   YES: Go to "DIAGNOSIS PROCEDURE ".

   NO: Go to 3.

With CONSULT-III 

1. Maintain the following conditions for at least 20 consecutive seconds.
   ENGINE OPERATING CONDITION CHART
   
   

   ENG SPEED	1,200 - 3,175 RPM (A constant rotation is maintained.)
   COOLAN TEMP/S	More than 65°C (149°F)
   < R > Selector lever	1st or 2nd position
   Driving location	Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)

   CAUTION: Always drive at a safe speed.

With GST 

Follow the procedure "With CONSULT-III" above.

Is 1st trip DTC detected? 

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END