Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2011 >> Cube Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTC P0507 Through DTC P2A00 (For CALIFORNIA) >> DTC P2122, P2123: App Sensor >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK GROUND CONNECTION
    1. Turn ignition switch OFF.
    2. Check ground connection E38. Refer to "CIRCUIT INSPECTION ".

      Is the inspection result normal? 

      YES: Go to 2.

      NO: Repair or replace ground connection.

  2. CHECK APP SENSOR 1 POWER SUPPLY CIRCUIT
    1. Disconnect accelerator pedal position (APP) sensor harness connector.
    2. Turn ignition switch ON.
    3. Check the voltage between APP sensor harness connector and ground.
      VOLTAGE REFERENCE CHART

      APP sensor Ground Voltage
      Connector Terminal
      E110 4 Ground Approx. 5 V

      Is the inspection result normal? 

      YES: Go to 3.

      NO: Repair open circuit or short to ground or short to power in harness or connectors.

  3. CHECK APP SENSOR 1 GROUND CIRCUIT FOR OPEN AND SHORT
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check the continuity between APP sensor harness connector and ECM harness connector.
      CONTINUITY CHART

      APP sensor ECM Continuity
      Connector Terminal Connector Terminal
      E110 2 E16 111 Existed
    4. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: Go to 4.

      NO: Repair open circuit or short to ground or short to power in harness or connectors.

  4. CHECK APP SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
    1. Check the continuity between APP sensor harness connector and ECM harness connector.
      CONTINUITY CHART

      APP sensor ECM Continuity
      Connector Terminal Connector Terminal
      E110 3 E16 110 Existed
    2. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: Go to 5.

      NO: Repair open circuit or short to ground or short to power in harness or connectors.

  5. CHECK APP SENSOR

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: Go to  7.

    NO: Go to 6.

  6. REPLACE ACCELERATOR PEDAL ASSEMBLY

    Replace accelerator pedal assembly. Refer to "REMOVAL AND INSTALLATION ".

    INSPECTION END

  7. CHECK INTERMITTENT INCIDENT

    Refer to "INTERMITTENT INCIDENT ".

    INSPECTION END

scientia non olet · About Mike's Workshop Manuals