Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2010 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Control System - Introduction (MR20DE) (Except CALIFORNIA)) >> Service Information >> Basic Service Procedure >> Fuel Pressure Check >> Without Consult-III

Without Consult-III

WARNING: This page is about a different variant/trim than selected.
  1. Remove fuel pump fuse (1) located in IPDM E/R (2).
    • <=: Vehicle front
  2. Start engine.
  3. After engine stalls, crank it two or three times to release all fuel pressure.
  4. Turn ignition switch OFF.
  5. Reinstall fuel pump fuse after servicing fuel system.
    Fig 1: Identifying Fuel Pump Fuse And IPDM E/R
    G04925143Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals