Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2010 >> Rogue SL, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (MEXICO) >> DTC/Circuit Diagnosis >> Ignition Signal >> Component Inspection (Condenser-1)

Component Inspection (Condenser-1)

  1. CHECK CONDENSER-1
    1. Turn ignition switch OFF.
    2. Disconnect condenser-1 harness connector.
    3. Check resistance between condenser-1 terminals as follows.
    RESISTANCE SPECIFICATION

    Terminals Resistance
    1 and 2 Above 1 MΩ [at 25°C (77°F)]

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Replace condenser-1.

scientia non olet · About Mike's Workshop Manuals