Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2010 >> Rogue SL, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (MEXICO) >> DTC/Circuit Diagnosis >> DTC P0222, P0223: TP Sensor >> Component Inspection

Component Inspection

  1. CHECK THROTTLE POSITION SENSOR
    1. Turn ignition switch OFF.
    2. Reconnect all harness connectors disconnected.
    3. Perform , "THROTTLE VALVE CLOSED POSITION LEARNING : SPECIAL REPAIR REQUIREMENT ".
    4. Turn ignition switch ON.
    5. Set selector lever to the D position.
    6. Check the voltage between ECM harness connector terminals.
    VOLTAGE SPECIFICATION

    ECM Condition Voltage
    + -
    Connector Terminal Connector Terminal
    F8 37
    (TP sensor 1 signal)    		 F8 36
    (Sensor ground)    		 Accelerator pedal Fully released More than 0.36 V
    Fully depressed Less than 4.75 V
    38
    (TP sensor 2 signal)    		 Fully released Less than 4.75 V
    Fully depressed More than 0.36 V

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: GO TO 2.

  2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
    1. Replace electric throttle control actuator.
    2. Perform , "SPECIAL REPAIR REQUIREMENT ".

    INSPECTION END

scientia non olet · About Mike's Workshop Manuals