Data Monitor Mode
Display Item List
MONITOR ITEM CHART
| x: Applicable ↓: Optional item | |||
|---|---|---|---|
| Monitor item (Unit) | SELECT MONITOR ITEM | Remarks | |
| ECU INPUT SIGNALS | MAIN SIGNALS | ||
| FR LH SENSOR [km/h (MPH)] | x | x | Wheel speed |
| FR RH SENSOR [km/h (MPH)] | x | x | |
| RR LH SENSOR [km/h (MPH)] | x | x | |
| RR RH SENSOR [km/h (MPH)] | x | x | |
| STOP LAMP SW (On/Off) | x | x | Stop lamp switch signal status |
| BATTERY VOLT (V) | x | x | Battery voltage supplied to the ABS actuator and electric unit (control unit) |
| GEAR | x | x | Gear position determined by TCM |
| OFF SW (On/Off) | x | x | VDC OFF switch |
| YAW RATE SEN (d/s) | x | x | Yaw rate detected by yaw rate/side/decel G sensor |
| DECEL G-SEN (G) | x | x | Decel G detected by yaw rate/side/decel G sensor |
| ACCEL POS SIG (%) | x | ↓ | Throttle actuator opening/closing is displayed (Linked with accelerator pedal) |
| SIDE G-SENSOR (m/s2 ) | x | ↓ | Transverse G detected by yaw rate/side/decel G sensor |
| STR ANGLE SIG (°) | x | ↓ | Steering angle detected by steering angle sensor |
| ENGINE RPM [tr/min (rpm)] | x | ↓ | Engine speed |
| FLUID LEV SW (On/Off) | x | ↓ | Brake fluid level switch signal status |
| FR RH IN SOL (On/Off) | ↓ | x | Operation status of each solenoid valve |
| FR RH OUT SOL (On/Off) | ↓ | x | |
| FR LH IN SOL (On/Off) | ↓ | x | |
| FR LH OUT SOL (On/Off) | ↓ | x | |
| RR RH IN SOL (On/Off) | ↓ | x | |
| RR RH OUT SOL (On/Off) | ↓ | x | |
| RR LH IN SOL (On/Off) | ↓ | x | |
| RR LH OUT SOL (On/Off) | ↓ | x | |
| MOTOR RELAY (On/Off) | ↓ | x | Motor and motor relay operation |
| ACTUATOR RLY (On/Off) | ↓ | x | Actuator relay operation |
| ABS WARN LAMP (On/Off) | ↓ | x | ABS warning lamp |
| OFF LAMP (On/Off) | ↓ | x | VDC OFF indicator lamp |
| SLIP LAMP (On/Off) | ↓ | x | SLIP indicator lamp |
| N POSI SIG (On/Off) | ↓ | ↓ | N range status |
| P POSI SIG (On/Off) | ↓ | ↓ | P range status |
| R POSI SIG (On/Off) | ↓ | ↓ | R range status |
| CRAKING SIG (On/Off) | ↓ | ↓ | CAN mask request for cranking |
| CV1 (On/Off) | ↓ | ↓ | Cut valve 1 monitor |
| CV2 (On/Off) | ↓ | ↓ | Cut valve 2 monitor |
| SV1 (On/Off) | ↓ | ↓ | Suction valve 1 monitor |
| SV2 (On/Off) | ↓ | ↓ | Suction valve 2 monitor |
| STOP LAMP SW2 (On/Off) | ↓ | ↓ | ASCD brake switch signal status |
| EBD SIGNAL (On/Off) | ↓ | ↓ | EBD operation |
| ABS SIGNAL (On/Off) | ↓ | ↓ | ABS operation |
| TCS SIGNAL (On/Off) | ↓ | ↓ | TCS operation |
| VDC SIGNAL (On/Off) | ↓ | ↓ | VDC operation |
| EBD FAIL SIG (On/Off) | ↓ | ↓ | EBD fail-safe status |
| ABS FAIL SIG (On/Off) | ↓ | ↓ | ABS fail-safe status |
| TCS FAIL SIG (On/Off) | ↓ | ↓ | TCS fail-safe status |
| VDC FAIL SIG (On/Off) | ↓ | ↓ | VDC fail-safe status |
| 4WD MODE MON (On/Off) | ↓ | ↓ | AWD mode monitor |