Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2010 >> Cube Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0181 To P0607 >> P0443 EVAP Canister Purge Volume Control Solenoid Valve >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    TESTING CONDITION: 

    • Perform DTC CONFIRMATION PROCEDURE when the fuel is between 1/4 and 3/4 full, and vehicle is placed on flat level surface. 
    • Always perform test at a temperature of 5 to 60°C (41 to 140°F). 
    • Cool the vehicle so that engine coolant temperature becomes same level as ambient temperature. 

    Do you have CONSULT-III 

    YES: GO TO 2.

    NO: GO TO  4.

  2. PERFORM DTC CONFIRMATION PROCEDURE A

    With CONSULT-III 

    1. Turn ignition switch ON.
    2. Select "DATA MONITOR" mode with CONSULT-III.
    3. Check that the following condition are met.

      FUEL T/TMP SE: 0 - 35°C (32 - 95°F)

    4. Start engine and wait at least 60 seconds.
    5. Check 1st trip DTC.

    Is 1st trip DTC detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: GO TO 3.

  3. PERFORM DTC CONFIRMATION PROCEDURE B

    With CONSULT-III 

    1. Start engine and warm it up to normal operating temperature.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Turn ignition switch ON.
    4. Select "PURG VOL CN/V P1444" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-III.
    5. Touch "START".
    6. Start engine and let it idle until "TESTING" on CONSULT-III changes to "COMPLETED". (It will take approximately 10 seconds.)

      If "TESTING" is not displayed after 5 minutes, retry from step 2. 

    7. Touch "SELF-DIAG RESULT".

    Which is displayed on CONSULT-III? 

    OK: INSPECTION END

    NG: Go to "DIAGNOSIS PROCEDURE ".

  4. PERFORM DTC CONFIRMATION PROCEDURE A

    With GST 

    1. Turn ignition switch ON.
    2. Check the voltage between ECM harness connector and ground.
      TERMINAL VOLTAGE REFERENCE CHART

      ECM Ground Voltage (V)
      Connector Terminal
      F8 43 (Fuel tank temperature sensor signal) Ground 3.1 - 4.0
    3. Start engine and wait at least 60 seconds.
    4. Check 1st trip DTC.

    Is 1st trip DTC detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: GO TO 5.

  5. PERFORM DTC CONFIRMATION PROCEDURE

    With GST 

    1. Start engine and warm it up to normal operating temperature.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Start engine and let it idle for at least 20 seconds.
    4. Check 1st trip DTC.

    Is 1st trip DTC detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals