Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

Turn ignition switch OFF.
Connect "GST" to data link connector, which is located under LH dash panel near the hood opener handle.
Turn ignition switch ON.
Enter the program according to instruction on the screen or in the operation article.
(*: Regarding GST screens in this part, sample screens are shown.)

Fig 1: Generic Scan Tool Screen Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Perform each diagnostic mode according to each service procedure.
For further information , see the GST Operation article of the tool maker.

Fig 2: Generic Scan Tool Display - READINESS TESTS

Courtesy of NISSAN MOTOR CO., U.S.A.